The D Cell Solvent Trap Kit is easy to assemble and use; just screw End Cap, 3 Lug adapter onto tube, booster onto the 3 Lug adapter and screw the unit onto the muzzle end of your barrel. The trap will catch the solvent you pour through your barrel to clean it. Recycle your solvent to save money and to be environmentally conscious.
Included in Kit
Titanium Tube
Titanium End Cap
Titanium 3 Lug Adapter
9/16X24 Booster
Specs:
- Outside Diameter 1.500″ (Titanium)
- Inside Diameter 1.360″ (Titanium)
- Tubes are available in Titanium
- Tubes Length is 3.6"
- Unfinished Titanium end cap
- Unfinished Titanium 3 Lug adapter
- 9/16X24 Booster
- Please follow all NFA laws. Modification of solvent trap parts without an approved tax stamp could be considered a felony.
Add one of the following 6 Cerakote Colors to any of our Solvent Trap Kits
- Flat Dark Earth
- Graphite Black
- OD Green
- Desert Sand
- Sniper Grey
You can build your own kit, just pic your tube, end cap and thread protector or Quick Attach Adapter!
Boosters are Anodized black and CAN NOT be Cerakoted but the Tube and End Cap can be in one of the 6 colors noted above.
Non-fixed pistol barrels need a booster for our solvent traps to
work properly because of the guide rod that protrudes from the front of these
pistols when the slide is charged or put into the battery. The bottom of the
solvent trap cleaning system blocks the guide rod from moving out completely,
which in turn blocks the firearm slide from moving backward into an open and
locked position.
The booster acts as an extension so the slide can fully “rack”,
allowing barrel snakes, cleaning rods, and solvents the necessary room to fit
through the ejection port area and into the barrel for cleaning.
Our booster fits our B cell tubes with a direct thread and D cell tubes with our 3 lug adapter as seen in the kit
